OCEANIS 351 BENETEAU is an elegant and comfortable sailboat designed for pleasant sailing with family or friends. Its spacious cockpit, clear deck plan, and harmonious lines will provide you with performance and ease of maneuvering. Its warm and well-arranged interior with its 3 double cabins and ample storage will charm you for life on board.

Well-maintained sailboat by its owner. It awaits its new crew at PORT MARITIMA – MARTIGUES.

Volvo Penta three-cylinder engine series 2003B – 28 HP (3009h)

Annual maintenance performed by the owner with invoices for parts purchased from the VOLVO dealer.

The 4 engine mounts were changed in 2017.

Every year the engine has been drained for 100h + gearbox, filters replaced + cooling pump.

Every 2 years, disassembly and cleaning of the heat exchanger, exhaust elbow, cleaning of the cooling circuit and replacement of the fluid as well as all the seals.

Replacement of the alternator belt every 3 years as well as the engine valve.

Engine panel with tachometer, hour meter, alarm indicator, and fuel gauge.

Shaft line protected by a molded polyester skeg in the hull.

Fixed three-blade propeller with anode.

Stainless steel steering wheel bar with a diameter of 1.06m with a console for navigation instruments.

Fuel capacity: 100l

Accommodations:

Version with 3 double cabins with 3 opening portholes in each cabin + storage unit, cupboard + wardrobe – Forward cabin (2.20mx1.80m) – 2 symmetrical aft cabins (2.00mx1.20m)

High-density mattresses with a 20cm custom LATEX slatted base for the forward cabin.

HSB:1.90M

Galley corner

2 stainless steel sinks with hot/cold pressurized water mixer.

25l water heater operating on 220v at dock/engine.

Cupboards, drawers, lockers.

ENO 2-burner stove + gas oven.

Danfoss refrigerator 130l.

Tableware for six people and many accessories.

Square:

Dining table with marquetry and molded wood, possibility to convert into a bed, storage chest + bar on starboard.

4 fixed hull portholes and 4 opening portholes. Upholstery fabrics, curtains, wooden floor in good condition.

Chart table in the direction of travel with storage and navigator's seat.

Bathroom:

Headroom 1.85m against integral molding.

Sink with hot/cold mixer with direct discharge to the sea via an electric pump.

Lighting, cupboard, mirror, marine toilet with manual pump, opening porthole.

2 rigid polyester tanks for fresh water 2 x 200l: 400l.

Sails & Rigging:

Mat Z SPARS with 2 levels of aluminum shrouds replaced in 2008 by a professional.

Navigation lights, VHF antenna, Autohelm wind/Anemometer, Spi rigging at the top of the mast, masthead light, spotlight.

Boom with rigid downhaul.

Standing rigging replaced in 2008, running rigging replaced in 2008, removable forestay with stainless steel pelican hook, backstay with wheel adjuster, FURLEX genoa furler installed in 2018 with new 8mm halyard, HARKEN blocks.

Mainsail with incidence (29m2) offshore 3 reefs in Dacron (2008) + protective cover.

GENOA Triradial (31m2) 2015.

Furling genoa Elvstrom with UV strip + protective cover.

Incidences storm jib 4m2 on removable forestay.

Asymmetrical spinnaker tri-radial Incidences 70m2 with sock and bag (2008) very little used.

A complete set of maneuvers for the sails + sail bags + spare rigging.

2 Lewmar ST44 winches for sheets and maneuvers at the cockpit.

2-block locking pulleys, all leads to the cockpit, Spinlock clutches...

Electricity on board:

LED lights in all cabins and saloon with switches, 12v electrical panel with circuit breakers.

Victron 12/30A battery charger (2013), Victron Blue Solar MPPT solar panel controller (2013).

3 batteries (2 service Victron AGM 12V-110Ah + 1 x 70Ah).

125w solar panel mounted on bimini – Pre-wiring for additional solar panels, battery cuts, 2 12v sockets with differential circuit breaker..

Electronics:

Outside:

RAYMARINE EV1 ACU 200 autopilot type1 (2015), installed on the steering sector under the cockpit.

Raymarine P70 repeater on the steering console.

Repeater Wind/Anemometer Autohelm + Speedo Log Sonar.

GPS repeater on the steering console.

Furuno Radar.

VHF ASN-AIS Navicom RT650 with combined and MOB bracelet.

Waterproof portable VHF (2018).

Furuno Navtex receiver – Raymarine E7 chart plotter connected to AIS + Navionics charts.

Radio CD WITH square/ext HP.

Miscellaneous:

Survival raft 6p (2019) on stainless steel frame to be revised.

Cockpit cover with steel arches + canvas.

Sunshade, fixed cockpit table with incorporated cooler.

Stainless steel steering wheel with console.

Bombard AX3 dinghy (2007) + Mercury 3.3hp engine (2 strokes).

Boom pole, mooring lines, gas bottles, rear skirt integrated into the hull with retractable bathing ladder, cockpit shower...

Electric windlass Lofrans 1000w + Britanny anchor 14 kgs + secondary anchoring with a Fortress anchor + 30m of chain.

Major works:

2023:

Renovation of the keel stripped, epoxy primer in multilayer + antifouling.

Repair and replacement of the plexiglass of the new descent cover.

Improvement of the square cover.

Installation and fitting of Lazy bag + Lazy jack.

2022:

Total refurbishment of the exterior teak square.

Complete engine revision (belt, impeller, oil change, filters).

2021:

Installation of a VICTRON charge controller.

Installation of 1 Victron 12V/230V inverter.

Refurbishment of the solar energy production network with the installation of an additional panel.

Replacement of the forward deck panel.

Replacement of the elbow exchanger + new Volvo part seal.

Replacement of the 2 service batteries + engine battery.

Cleaning and greasing of the winches.

For information, the previous owner replaced the 4 engine mounts in 2017, in 2018 installed a new Furlex furler + changed the forestay, replaced the hydrolube ring + keel seal.

Please contact Jean-Marc - at 04.42.81.16.02